Home » » Cara membuat kabel RS 232 untuk flash receiver

Cara membuat kabel RS 232 untuk flash receiver

Written By adeen sat on Sunday, February 24, 2013 | Sunday, February 24, 2013

1. Cutting lines on the RS-232 cable is about 1 meter long, 4-core telephone wire size 0.5 - 0.65 SQ.mm. then peel the outer side of the second 3 to 3.5 cm long and strip the wires to length. approximately 1.5 to 3.5 mm, as shown below.
Cara membuat kabel RS 232 untuk flash receiver
2. After stripping the cable and connect one end of the cable into the tail. Then squeeze the tail attached to the copper wires.
Cara membuat kabel RS 232 untuk flash receiver
3. Tail at him and he heads 3 Pin RS-232, and the head and then turned the canine's head 3 pin count from left to right as a sequence 1 (red), 2 (yellow), and 3. (green) to bring to a head a DB9 RS-232 and RS 232 side by side, head to Pin 5, 3 and 2 respectively of the head DB 9 RS-232.
Cara membuat kabel RS 232 untuk flash receiver
4. Introduce more guns stepped down on both sides to prevent the fall of the joints caused by the need to pull cables - off the tension of the cable.
Cara membuat kabel RS 232 untuk flash receiver
5. Tests to load the software in the first shot with a glue gun. (The final line item 4) to prevent connection errors.
Share this article :

0 komentar:

Post a Comment

Note: Only a member of this blog may post a comment.

Popular Posts

 
Copyright © 2013. kaleefaanfield - All Rights Reserved
Proudly powered by Blogger